DoubleTake Scrambler Mirror - with RAM Long Double Socket Arm and RAM M10 x 1.25 Ball Base
* Indestructible- Made from reinforced Zytel
* Excellent visibility- SAE spec convex lens
* Housing guaranteed against breakage
* Ball base has M10 x 1.25 thread
* RAM ball and Double Socket arm combination gives maximum adjust-ability
* Made in USA
This kit is designed to replace your factory mirrors. The ball base screws into the mirror post base on most bikes (see note below). Recommended for applications where mirror will be extended most of the time, although it still folds very well
Mirror Diameter = 100mm (4")
Overall length = 150mm (6")
Base Thread Pitch
M10-1.25 x 7/16"
Ball Size
1" Ball
Compatibility:
Threaded hole must contain the following dimensions for this base to fit: M10 1.25 pitch with a 14.5mm flange diameter with a 10.15mm thread length
Arm Dimensions:
Overall:
152 mm (6")
Socket-To-Socket:
134 mm (5.25")
Components:
DTM-SC DoubleTake Scrambler Mirror
RAM-B-201U-C DBL SOCKET ARM B BALL C LENGTH
RAM-B-349U BASE W/ M10 X 1.25 PITCH & 1" BALL
YouTube:
https://www.youtube.com/watch?v=DkW_hahu5vo
https://www.youtube.com/watch?v=C8mDODfi2_o&list=TLGGzK26BgaN84kwMjA5MjAyMQ
https://www.youtube.com/watch?v=9OdChYlKTWQ&list=TLGGqEM5kehrThcwMjA5MjAyMQ
Note: The right-hand mirrors on certain models of Yamaha, Beta, and certain KTM bikes may require a reverse thread adaptor. Some models (WR250s) are factory equipped with a reverse thread adapter. Please verify if your specific bike is equipped with the reverse thread adaptor on the right side before ordering.
Note: We stock reverse thread and other adaptors where required.
Note: This is single mirror, arm and adaptor
Note: Riders with BMW's (and others) that use an M8 x 1.25 thread might consider substituting the RAM-B-349U base with the RAM-B-367U - get in touch if you need to do this - either that or add the DTM-BMW adaptor base
