RAM X-Grip Universal SmartPhone Cradle - Low Profile Tough-Claw Handlebar Base

RAM-HOL-UN7-400-2U RAM® X-Grip® Phone Mount with Low-Profile Small Tough-Claw™


Features

* Low profile phone mount clamps to your handlebar with the turn of a single knob
* Small version of the RAM® Tough-Claw™ base is designed to quickly clamp to round, square, and odd-shaped rails and bars ranging from 16-28mm in outer diameter; rubber pads provide stable gripping and protection of mounting surface
* Spring-loaded 'X' design for standard size phones with rubber caps sports great holding power without hiding your phone; includes optional device tether for peace of mind during rugged use; check compatibility section below to see if your phone will fit
* Made of high-strength composite and stainless steel hardware for durability and reliability in the most demanding environments
* Backed by a lifetime warranty


The RAM® X-Grip® Phone Mount with Low-Profile RAM® Tough-Claw™ (RAM-HOL-UN7-400-2U) consists of the small RAM® Tough-Claw™ base and universal large RAM® X-Grip® phone holder, connected by the RAM® Pin-Lock™ adapter. The RAM® X-Grip® features an ‘X’ design that expands and contracts to secure your phone, and includes a device tether recommended for outdoor applications.

With the RAM® Tough-Claw™ base connected, easily attach the RAM® X-Grip® on round, square, and odd-shaped rails and bars ranging from .625” to 1.14” in outer diameter. This kit is compatible with handheld devices that will fit the dimensions listed below. It is important to verify the dimensions of your handheld device with its case, sleeve, or skin when determining the overall size.


The included -UN7 X-Grip cradle has a clean and clever four leg design that sports great holding power without hiding your phone behind foam pads and plastic. The spring loaded X-Grip holder expands and contracts, allowing for a perfect custom fit of your cell phone. This mount rotates 360 degrees.


The X-Grip includes a device tether recommended for outdoor applications.


The cradle is compatible with hand-held devices that will fit the dimensions listed below. Please verify the dimensions of your hand-held device with a case/sleeve/skin when determining the overall size


Cradle Dimensions
Minimum Width = 47.6mm (1.875”) – if it is minimum width then the minimum height = 108mm (4.25")
Maximum Width = 82.6mm (3.25") – if it is maximum width then the minimum height = 57.2mm (2.25")
Maximum Thickness = 22.2mm (0.875")


Compatible Devices
For a list of many of the compatible devices for this cradle go to our listing for the RAM-HOL-UN7BU


Clamping Range
Rail/Tubes:
15.9 - 28mm (0.625" to 1.14")
Flat Surfaces:
0" to 28mm (1.14")


Material:
High Strength Composite
Stainless Steel

Weight:
226 grams


YouTube:
https://www.youtube.com/watch?v=gSplxuUrtmQ
https://www.youtube.com/watch?v=S8ky_uKTw98
https://www.youtube.com/watch?v=rX36fAdknUY
https://www.youtube.com/watch?v=99m0rbNY-FQ

QUESTIONS & ANSWERS
Q: I noticed my phone can be rotated back and forth about 15 degrees when it is in the X-Grip. Is that normal?

A That type of movement is totally normal for the X-Grip. When being used for less rugged applications the small amount of movement allowed is not an issue, but sometimes when traveling at higher speeds or in bumpy environments it can be. If that is causing problems in your application, it is best to use the safety tether which will prevent that type of movement by creating tension between the phone and backplate.