DoubleTake Enduro Mirror Kit - Short Arm and Ball Base

DoubleTake Enduro Mirror Kit with RAM Double Socket Arm and RAM M10 x 1.25 Ball Base

Features:

* Indestructible- Made from reinforced Zytel
* Excellent visibility- SAE spec convex lens
* Easy to fold, remove, or swap between bikes
* Housing guaranteed against breakage
* RAM ball and Double Socket arm combination gives maximum adjust-ability
* 60 mm short RAM double socket arm included
* M10 x 1.25 Male Thread Ball Base included
* Made in the USA


This kit is designed to replace your factory mirrors. The ball base screws into the mirror post base on most bikes (see note below). Recommended for applications where mirror will be folded down often.

Mirror Dimensions
Diameter = 100mm (4")
Length = 215mm (8.5")



Compatibility:
Threaded hole must contain the following dimensions for this base to fit: M10 1.25 pitch with a 14.5mm flange diameter with a 10.15mm thread length

RAM-B-349U base Thread Pitch:
M10-1.25 x 7/16"


Arm Dimensions:
Overall: 60.5mm (2.38")
Socket-To-Socket: 51mm (2")


Components:
DTM-A DoubleTake Adventure Mirror
RAM-B-201U-A Short DBL Socket Arm
RAM-B-349U BASE W/ M10 X 1.25 PITCH & 1" BALL

YouTube:
https://www.youtube.com/watch?v=C8mDODfi2_o&list=TLGGzK26BgaN84kwMjA5MjAyMQ
https://www.youtube.com/watch?v=9OdChYlKTWQ&list=TLGGqEM5kehrThcwMjA5MjAyMQ

Note: The right-hand mirrors on certain models of Yamaha, Beta, and certain KTM bikes may require a reverse thread adaptor. Some models (WR250s) are factory equipped with a reverse thread adapter. Please verify if your specific bike is equipped with the reverse thread adaptor on the right side before ordering.

Note: We stock reverse thread and other adaptors where required.

Note: Riders with BMW's (and others) that use an M8 x 1.25 thread might consider substituting the RAM-B-349U base with the RAM-B-367U - get in touch if you need to do this ($3 extra)- either that or add the DTM-BMW adaptor base